Electrolux 134912700 User Manual
19
Reversing Door
1 Be sure you have adequate swing area before reversing door.
2 You will need a screw driver with a #2 square bit.
3 Protect flat work surface, such as top of dryer or floor near dryer,
2 You will need a screw driver with a #2 square bit.
3 Protect flat work surface, such as top of dryer or floor near dryer,
with a soft cloth or towel.
4 Be sure dryer is unplugged from power source!
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing
could result in personal injury or even death.
could result in personal injury or even death.
A) Removing Trim Ring
1 Open door to 90 degree angle.
2 Remove and save trim plug and long,
2 Remove and save trim plug and long,
course-thread, panhead screw.
3 Close door.
4 Rotate door trim approximately ¾” counter-
4 Rotate door trim approximately ¾” counter-
clockwise and pull ring away from door.
4 Gently place door face down on flat, covered
work surface.
3 While supporting door with the other hand,
remove 3 short, fine-thread, counter-sunk
screws.
screws.
B) Removing Door from Front Panel
1 Reopen door to 90 degree angle.
2 Remove 2 short, course-thread, panhead
2 Remove 2 short, course-thread, panhead
screws.
Preparing to reverse door swing
Removing door and hardware
Screwdrivers with
#2 square &
straight bit
Tools needed: