Olympus 260116 User Manual

EN

The flash light intensity is controlled automatically by measuring the 
amount of light through the auto light receptor. This mode uses the 
settings on the camera together with the settings on the electronic 
flash.

  The control panel shows the light control 

range according to the camera’s setup.

 The light control range is not displayed if 

the camera’s setup (ISO sensitivity and 
aperture value) does not match one of 
the usable ISO sensitivity/aperture value 
combinations. In this case, the [ISO] and 
[F] indicators blink to alert you. Change 
the camera’s setup (ISO sensitivity and/or 
aperture value). 

g “Light control range in 

AUTO mode” (P. 47)

  When flash activation has been 

performed correctly, the AUTO CHECK 
lamp blinks for about 5 seconds after 
the shutter is released.

Light control 
range

Firing angle
Displayed according 
to the focal length of 
the lens.

Flash activation can be tested before actually releasing 
the shutter.
Press the TEST button for test flash activation.
If the AUTO CHECK lamp blinks for about 5 seconds after 
the test flash activation, the flash is adjusted correctly.
If the lamp does not blink, change the aperture value, ISO 
sensitivity, subject distance, etc.

 Checking the light by means of test flash activation is 

possible only in AUTO mode.

TEST 
button

AUTO CHECK 
lamp

e00_r2062_cs2j.indb   16

e00_r2062_cs2j.indb   16

2007/08/01   14:43:57

2007/08/01   14:43:57