ARRI 416 User Manual

Note: 

The automatic image compensation locks in two 

positions 180° apart. This allows the image 

compensation to be set to provide an upright 

image when using a finder extension.

If the viewfinder image is inverted without the finder 

extension, the image compensation must be adjusted to 

the opposite locking position.

•  Press the locking button 

a

 and keep pressed.

•  Turn the adjustment knob 

a

.

•  Release the locking button 

a

.

•  Keep turning the adjustment knob 

a

 until the 

locking button pops up and the adjustment knob locks 

in position.

Before removing the viewfinder system, the viewfinder 

arm should be brought back to its normal position.

•  Loosen the three fastening screws 

a

.

•  Pull the viewfinder system up and off the camera body.

•  If the camera is to be used without the viewfinder, fit 

the cover to protect the beamsplitter prism.

•  Position the viewfinder system on the camera body 

from above.

•  Tighten the fastening screws.

A LED glows when the camera is not running at the set 

speed (ASY). This LED blinks when the battery voltage is 

low (BAT).

screws

locking button

adjustment knob