Hasselblad 10026 User Manual

13355

13362

13280

13356-1

816720

30727

Cover 22813

814827

13108

821631

Fit the stop lever (13355) and spring (816752) to the
pre-greased hub. Secure with the clip (817119).

Lubricate the hub (13108) with grease and place a shim
onto it. This shim can be in several thicknesses for
adjustment as follows: 0.10; 0.20; 0.30 mm with
corresponding part numbers 810826, 810827, 810828.
Attach spring (814827) between the auxiliary shutter
stop (22436) and the right hand wall.
Fig. 19.

On the reverse side of the right hand wall fit the mirror
actuating lever (13362) and the lens lock (13280).
Lubricate with grease. The lens lock pin (13280) fits
into a pin on the mirror actuating lever.
Fig. 20.

Secure the mirror actuating lever (13362) temporarily
with screw (821631) from the other side according to
Fig. 19.

Fit the mirror catch 13356-1 onto the pin. Lubricate
with grease. Connect the spring (816720) with its long
shackle in the hole in the right hand wall and the short
one under the mirror catch.
Hold the blocking lever and spring and install the push
fit cover (30727). Check that the mirror catch moves
freely.
Fig. 21.

Connect the right and left hand walls to the bottom
plate (30686), secure with six screws (820014).
Apply safety lacquer to screw-threads.
Put back the foam plastic pad (22582).

Put the focusing screen frame back and at the same time
secure the upper part of the inner side cover (22813).
Fit the spring (30755) and secure with screws (829425).
Fit four screws (820015), two through the right hand
wall and two (temporarily) through the left hand wall.
Fig. 22.