Konica Minolta DiMAGE S414 User Manual
16
GETTING UP AND RUNNING
CHANGING BATTERIES
Insert the batteries. Make sure the positive and negative battery
terminals are oriented as illustrated on the diagram in the battery
chamber.
terminals are oriented as illustrated on the diagram in the battery
chamber.
This digital camera uses four AA-size alkaline or Ni-MH batteries. Ni-MH batteries are recommended
because of longer life. When using Ni-MH batteries, fully recharge them with a battery charger
suitable for complex electronic equipment. Please consult your vendor about an appropriate charger.
because of longer life. When using Ni-MH batteries, fully recharge them with a battery charger
suitable for complex electronic equipment. Please consult your vendor about an appropriate charger.
When replacing batteries, the mode dial should be in the off
position. If the camera is not turned off when replacing
exhausted batteries, the low-battery warning may not reset.
position. If the camera is not turned off when replacing
exhausted batteries, the low-battery warning may not reset.
Close the battery-chamber door and slide it back toward the body (4) to
engage the safety catch. Move the lock lever (5) to the close position.
engage the safety catch. Move the lock lever (5) to the close position.
After installing the batteries, the set-time/date message may appear on
the monitor. The clock and calendar are set in the custom 2 section of
the setup menu (p. 20).
the monitor. The clock and calendar are set in the custom 2 section of
the setup menu (p. 20).
Open the battery-chamber door by moving the battery-chamber lock (1)
to the open position. Slide the door forward (2) to release the safety
catch; the door should spring open (3).
to the open position. Slide the door forward (2) to release the safety
catch; the door should spring open (3).
1
2
4
3
5