Kodak 800 SERIES User Manual
NovaJet 800 Series Service Manual
Assembly\Disassembly
5-7
Figure 5-3. E-Connect Assembly Installation/Removal.
3.
Put on an ESD wrist strap.
4.
Slowly lower the E-Connector Assembly until you can disconnect the
power cable from the connection located near the center of the circuit
board.
power cable from the connection located near the center of the circuit
board.
Install the E-Connect Network Assembly
1.
Connect the power cable to the connection located near the center of
the circuit board.
the circuit board.
2.
Hold the E-Connect Assembly in place and secure using 4 screws.
Torque to 15 in-lbs
Torque to 15 in-lbs
3.
Connect the small parallel cable and the network cable to the rear of
the E-Connect Assembly.
the E-Connect Assembly.