JVC GR-DVL120 User Manual

 EN

You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in and
outpoints. The original audio remains unchanged.

● Before performing the following steps, make sure that

“TIME CODE” is set to “ON” in the Menu Screen
(

墌

 pg. 35, 37).

● Insert Editing is not possible on a tape recorded in the

LP mode or on a blank portion of a tape.

● To perform Insert Editing while watching in the

television, make connections (

墌

 pg. 20).

Play back the tape, locate the Edit-Out point and

press PAUSE (6). Confirm the time code at this point
(

墌

 pg. 35, 37).

Press REW (2) until the Edit-In point is located,

then press PAUSE (6).

Press and hold INSERT (w) on the remote

control, then press PAUSE (6). “6w” and the Time
Code (min.:sec.) appear and the camcorder enters
Insert-Pause mode.

Press START/STOP to begin editing.

• Confirm the insert at the time code you checked in

step 1.

• To pause editing, press START/STOP. Press it

again to resume editing.

To end Insert Editing, press START/STOP, then

STOP (5).

● Programme AE with special effects (

墌

 pg. 24, 25) can

be used to spice up the scenes being edited during
Insert Editing.

● During Insert Editing, the date and time information

changes.

● If you perform Insert Editing onto a blank space on the

tape, the audio and video may be disrupted. Make sure
you only edit recorded areas.

● During Insert Editing, when the tape moves to scenes

recorded in the LP mode or a blank portion, Insert
Edting stops (

墌

 pg. 62).

w

6