Olympus E-5 User Manual
78
EN
5
Fl
ash sho
o
ting
In addition to the camera’s built-in flash capabilities, you can use any of the external flash
units specified for use with this camera. This enables you to take advantage of a wider variety
of flash shooting techniques to suit different shooting conditions.
The external flashes communicate with the camera, allowing you to control the camera’s
flash modes with various available flash control modes, such as TTL-AUTO and Super FP
flash. An external flash unit specified for use with this camera can be mounted on the camera
by attaching it to the camera’s hot shoe. You can also attach the flash to the flash bracket on
the camera using the bracket cable (optional).
Refer to the external flash’s manual as well.
Functions available with external flash units
Functions available with external flash units
* The focal length of the lens that can be used (Calculated based on 35 mm film camera)
x
Notes
• The FL-40 optional flash cannot be used.
Using the external electronic flash
Be sure to attach the flash to the camera before turning on the flash’s power.
1
Remove the hot shoe cover by sliding it
in the direction indicated by the arrow in
the illustration.
in the direction indicated by the arrow in
the illustration.
• Keep the shoe cover in a safe place to avoid
losing it, and put it back on the camera after
flash shooting.
flash shooting.
2
Attach the electronic flash to the hot
shoe on the camera.
shoe on the camera.
• If the lock pin is protruding, turn the shoe lock
ring as far as it will go in the direction opposite
to LOCK. This will pull the lock pin back
inside.
External flash shooting
Optional flash
FL-50R
FL-36R
RF-11
TF-22
Flash control mode
TTL-AUTO, AUTO, MANUAL,
FP TTL AUTO, FP MANUAL
TTL-AUTO, MANUAL
GN (Guide number)
(ISO100)
(ISO100)
GN50 (85 mm
*
)
GN28 (24 mm
*
)
GN36 (85 mm
*
)
GN20 (24 mm
*
)
GN11
GN22
RC mode
9
9
k
k
Hot shoe cover
Lock pin
Lock ring
s0033_e_00_0_unified.book 78 ページ ２０１０年１１月１６日 火曜日 午後５時２４分