Epson R-D1 User Manual

❏ The battery charger included is designed for use with this product. 

Use of any other battery charger could result in fire, electrical shock, 
or injury.

❏ Use only a power source that meets the power requirements 

indicated on the label attached to the product. If you are not sure 
of the power supply specifications in your area, contact your local 
power company or contact our Customer Support.

❏ Make sure the total amperage of all devices plugged into the power 

outlet does not exceed the power outlet’s ampere rating.

❏ If you plan to use this product in Germany, the building installation 

must be protected by a 16 amp circuit breaker to provide adequate 
short-circuit protection and over-current protection for this 
product.

❏ Do not use a damaged or frayed battery charger.
❏ If you use an extension cord with this product, make sure the total 

amperage of all devices plugged into the extension cord does not 
exceed the cord’s ampere rating.

❏ Never disassemble, modify, or attempt to repair the battery charger 

by yourself except as specifically explained in this guide.

❏ Do not use power outlets controlled by wall switches or automatic 

timers.

❏ Do not use power outlets on the same circuit as large motors or 

other appliances that may cause voltage fluctuations.

❏ Avoid using outlets on the same circuit as photocopiers or air 

conditioning systems that regularly switch on and off.

❏ Position this product’s power cord so that it will not be stepped on 

or run over.

❏ Do not place any objects on the power cord or the battery charger.
❏ Keep the power cord straight at the ends and at the points where 

it enters the transformer.

❏ The power cord should be placed to avoid abrasions, cuts, fraying, 

crimping, kinking, and other damage.

❏ If you cannot insert the plug into the power outlet, contact an 

electrician.

For US and Canadian users:

Use the power cord provided or a 6 to 10 foot UL-approved type SPT-2 
or heavier type, 2 X 18 AWG cord with a 125 V 10 A plug and 125 V 7 
A connector.

❏ Only memory cards designed for the product’s specifications can 

be used.

❏ The methods for using memory cards vary according to card type. 

Be sure to refer to the documentation included with your memory 
card for details.

❏ Do not remove the memory card while the power switch is on.

❏ The LCD monitor on this product may contain a few small bright 

or dark spots. These are normal and do not mean that your LCD 
monitor is damaged in any way.

❏ If the LCD monitor on this product is damaged, consult your 

dealer.

❏ If the liquid crystal solution contained in the LCD monitor on this 

product leaks out and gets onto your hands, wash them thoroughly 
with soap and water. If it gets into your eyes, flush them 
immediately with water. If discomfort or vision problems remain 
after a thorough flushing, see a doctor immediately.

❏ Only use a soft, dry cloth to clean the display. Do not use liquid or 

chemical cleaners.

❏ Do not store this product outdoors.