JVC FS-P400 User Manual

 

• Install in a place which is level, dry and neither too hot nor 

too cold—between 5°C and 35°C (41°F and 95°F).

• Install the System in a location with adequate ventilation to 

prevent internal heat buildup inside the System.

• Leave sufficient distance between the System and the TV.
• Keep the speakers away from the TV to avoid interference 

with TV.

 

• When unplugging the System from the wall outlet, always 

pull on the plug, not the AC power cord.

 

Moisture may condense on the lenses inside the System in 
the following cases:
• After starting to heat the room
• In a damp room
• If the System is brought directly from a cold to a warm 

place

Should this occur, the System may malfunction. In this case, 
leave the System turned on for a few hours until the moisture 
evaporates, unplug the AC power cord, then plug it in again.

 

• Should any metallic object or liquid fall into the System, 

unplug the AC power cord and consult your dealer before 
operating any further.

• If you are not going to operate the System for an extended 

period of time, unplug the AC power cord from the wall 
outlet.

If anything goes wrong, unplug the AC power cord and 
consult your dealer.

 

To make this manual as simple and easy-to-understand as 
possible, we have adapted the following methods:
• Button and control operations are explained as listed in the 

table below. In this manual, the operations using the 
remote control is mainly explained; however, you can use 
the buttons and controls on the main unit if they have the 
same (or similar) name and marks.

•

 

 If you want to know more 

about the functions, or if you have a doubt about the 
functions, go to these sections and you will find the 
answers.

DO NOT install the System in a location near 
heat sources, or in a place subject to direct 
sunlight, excessive dust or vibration.

DO NOT handle the AC power cord with wet 
hands.

DO NOT disassemble the System since there 
are no user serviceable parts inside.

 

Indicates that you press the button 

 

.

Indicates that you press the button 

 

 until an 

option you want is selected.

Indicates that you press one of the 
buttons.

Indicates that you 

 

 the 

button for specified seconds.
• The number inside the arrow 

indicates the period of press (in this 
example, 2 seconds).

• If no number is inside the arrow, 

press and hold until the entire 
procedure is complete or until you 
get a result you want.

Indicates that you turn the control 
toward the specified direction(s).

Indicates that this operation is only 
possible using the remote control.

Indicates that this operation is only 
possible using the buttons and controls on 
the main unit.

2

 sec.

 

Introduction.fm  Page 2  Monday, February 23, 2004  3:00 PM