Fujifilm S5 Pro Owner's Manual
147
Settings
Store information from a barcode reader or GPS
connected to a 10-pin terminal as Exif information.
connected to a 10-pin terminal as Exif information.
[BCR 1 SHOT]
Read barcode information for each shot and store it as
comment information. Pictures cannot be taken without
reading a new barcode.
comment information. Pictures cannot be taken without
reading a new barcode.
[BCR CONTINUOUS]
Store registered barcode information as comment
information in every file. To erase the registered
information, read the “barcode eraser” on this page or
delete the letters registered in the [IMAGE
COMMENT].
information in every file. To erase the registered
information, read the “barcode eraser” on this page or
delete the letters registered in the [IMAGE
COMMENT].
[GPS]
Store information from GPS device allowing latitude,
longitude, altitude and UTC (standard universal
coordinated time) to be recorded with photographs.
longitude, altitude and UTC (standard universal
coordinated time) to be recorded with photographs.
[OFF]
No store barcord or GPS information is retrieved.
MEMO
When the barcode information is stored,
BCD
is
displayed in the control panel.
Z Connecting to barcode reader
You can use the barcode reader with a D-sub 9-pin
connector (commercially available).Connect the barcode
reader to the camera using MC-35. See the barcode
reader instruction manual for details.
You can use the barcode reader with a D-sub 9-pin
connector (commercially available).Connect the barcode
reader to the camera using MC-35. See the barcode
reader instruction manual for details.
Barcode reader setting
• Baud rate: 4800 bps
• Data length: 8 bit
• Parity check: –
• Stop bit: 1 bit
• EOF: CR+LF
• Baud rate: 4800 bps
• Data length: 8 bit
• Parity check: –
• Stop bit: 1 bit
• EOF: CR+LF
Z Barcode eraser
Use the barcode reader to read the barcode below to
erase the last barcode information.
Use the barcode reader to read the barcode below to
erase the last barcode information.
Continued Q
BARCODE READER/GPS
How to use the SET UP menu (
➝p.138)