Sony XCD-SX90 User Manual
1-2
XCD-U100/SX90/V60
XCD-U100CR/SX90CR/V60CR
1-2-2. Rear Panel Assembly
1.
Remove the upper case and lower case.
(Refer to Section 1-2-1.)
(Refer to Section 1-2-1.)
2.
Remove the two screws, then pull out the rear panel
assembly.
assembly.
3.
Disconnect the flexible flat cable from the connector
(CN900) on the CN-3020 board.
(CN900) on the CN-3020 board.
4.
Attach the rear panel assembly in the reverse order of
steps 1 to 3.
n
When attaching the rear panel assembly, securely
attach it while pushing it against the chassis.
n
When attaching the rear panel assembly, securely
attach it while pushing it against the chassis.
CN-3020 board
CN900
Rear panel assembly
Flexible flat cable
PM2
x
4
PM2
x
4
Rear panel assembly
Chassis
1-2-3. Front Panel Assembly
n
When replacing the front panel assembly, perform the
When replacing the front panel assembly, perform the
writing the serial number and Node Unique ID and camera
adjustment. For details, refer to Sections 2-1 and 2-2.
adjustment. For details, refer to Sections 2-1 and 2-2.
1.
Remove the upper case and lower case.
(Refer to Section 1-2-1.)
2.
Remove the two screws, then pull out the front panel
assembly.
3.
Disconnect the flexible flat cable from the connector
(CN101) on the BI-217/218/219 board.
4.
Attach the front panel assembly in the reverse order of
steps 1 to 3.
n
steps 1 to 3.
n
When attaching the front panel assembly, securely
attach it while pushing it against the chassis.
attach it while pushing it against the chassis.
PM2
x
4
PM2
x
4
Front panel assembly
CN101
Flexible flat
cable
cable
BI-217/218/219 board
This illustration is for XCD-SX90/SX90CR.
Chassis
Front panel assembly