Sony DSC-T10 User Manual

Page of 32
9
DSC-T10
2-691-401-11(1)
E:\DSC-T10\2691401111\2691401111DSCT10U2\01GB-DSCT10\040PRE.fm
master:Right_PrepL2
1 Preparing the battery pack
1
Insert the battery pack into the battery charger.
2
Connect the battery pack to the wall outlet (wall socket).
The CHARGE lamp lights on, and charging starts.
When the CHARGE lamp turns off, charging is finished (Practical charge).
If you continue charging the battery pack for about one more hour (until it is fully charged), the charge 
will last slightly longer.
• Connect the battery charger to an easily accessible wall outlet (wall socket) close by.
• Even if the CHARGE lamp is not lit, the battery charger is not disconnected from the AC power source 
(mains) as long as it is connected to the wall outlet (wall socket). If some trouble occurs while using the 
battery charger, immediately shut off the power by disconnecting the plug from the wall outlet (wall 
socket).
• When charging is finished, disconnect the power cord (mains lead) from the wall outlet (wall socket), and 
remove the battery pack from the battery charger.
• The time required to fully charge the supplied battery pack from when it is completely discharged at a 
temperature of 25°C (77°F) is approximately 220 min., and the practical charging time is approximately 
160 min. Charging may take longer under certain circumstances or conditions.
ɟ
CHARGE lamp
plug
CHARGE lamp
Power cord (mains lead)
For customers in the USA and 
Canada
For customers other than those in the USA 
and Canada
ɟ