Panasonic WV-CW964 User Manual

-16-

• Make sure that the place you are installing the camera is strong enough to support it. If it is not strong enough,

then the camera may fall and hurt someone.

• The following steps of installation and connection work should be done by qualified service personnel or

system installers and should conform to all local codes.

• Be sure to turn the power off before installation and connection.
• Do not install the camera near the air outlet of an air conditioner.

■ Mounting the Camera

The figure shows an example of the camera mounted
on a ceiling with a locally procured bracket.
Refer to the instructions included with the bracket for
filling gaps and holes with waterproof material.

● Construction

● Assemble procedure

(1) Procure a ceiling mount bracket.

(2) To prevent the camera from falling, use a

mounting a bracket to which a safety wire can
be attached.

(3) Installation Surface

Caution: Consult an expert on the load bearing

capacity of the installation surface and
structure. If the surface is not strong enough,
the camera may fall down. Refer to the
product specifications for weights.

Prepare appropriate hardware (e.g. wall nuts,
anchor bolts, etc.) for fixing on the installation
surface.

(1) Remove the upper base from the camera by

loosening 3 screws. The screws that are
removed need to be used during reassembly.
Be careful to not lose them. Turn the upper base
and separate it.
* 

Special screw (mounting screw): Use a
hexagon wrench for the hexagon button screw
(M6).

(2) Remove the attachment pipe from the upper

base by loosening 4 screws.
* 

Special screw (mounting screw): Use a
hexagon wrench for the hexagon button screw
(M6).

(Ø

58)

(60)

25

85

40 1-1/2A deep 30 MAX
PT11 crest (parallel pipe thread)

40 1-1/2B deep 30 MAX
PT11 crest (taper pipe thread)

x3

x4

 WV-CW964  05.10.19  4:36 PM  ページ16