Panasonic DMC-L1K User Guide

Preparation

VQT0W82

Using the AC Adaptor

You can use the camera without worrying
about battery discharge when it is
connected to a PC or printer if you use the
AC adaptor.
• Check that the camera is turned off.
• Close the flash.

1 Connect the AC cable.

2 Connect the DC cable A.

• Pull open the DC cable cover

1 and

then connect the DC cable to the
camera body using the same steps as
“Inserting/Removing the Battery” (P20).
Pull the DC cable through the opening
as shown in the illustration and then
close the battery door.

• Be careful not to catch the DC cable

when closing the battery door.

• Do not use any other AC adaptors except

the supplied one.

• Do not use any other DC cables except

the supplied one. If you use other DC
cables, it may cause a malfunction.

• The camera becomes warm during use.

This is not a malfunction.

• Disconnect the AC adaptor and DC cable

when the camera is not in use.

Inserting/Removing
the Card (Optional)

• Check that the camera is turned off.
• Close the flash.
• Prepare a card.

1 Slide the card door to open it.

2 Insert:

Insert the card fully until it clicks
and it is locked.

Remove:
Push the card until it clicks, then
pull the card out upright.

• Check the direction of the card.

PUSH TO

LOCK / EJEC