Panasonic DMCLX3K User Guide

VQT1T27

The burst speed values given above apply when the shutter speed is 1/60 or faster and when 
the flash is not activated.

The burst speed becomes slower halfway. The exact timing of this depends on the type of 
card, the picture size and the quality.

You can take pictures until the capacity of the built-in memory or the card is full.

The focus is fixed when the first picture is taken.

When the burst speed is set to [˜], the exposure and white balance are fixed at the settings 
used for the first picture for the subsequent pictures as well. When the burst speed is set to 
[ò], they are adjusted each time you take a picture.

When the self-timer is used, the number of recordable pictures in burst mode is fixed to 3.

If you are following a moving subject while taking pictures in a place (landscape) indoors, 
outdoors etc. where there is a large difference between the light and shade, it may take time 
until the exposure is stable. If burst is used at this time, the exposure may not become optimal.

The burst speed (pictures/second) may become slower depending on the recording 
environment such as in dark places, if the ISO sensitivity is high etc.

Burst mode is not canceled when the camera is switched off.

If you take pictures in burst mode with the built-in memory, it will take time to write the picture 
data.

[Œ] is set for the flash when burst is set.

[REC] mode: 

±´

Set the aperture value to a higher number when you want a sharp focus background. Set 
the aperture value to a lower number when you want a soft focus background.

Set the [REC]/[PLAYBACK] selector switch to [!], and then set the 
mode dial to [

3/4 to set the 

When you want to take a sharp picture of a fast moving subject, set with a faster shutter 
speed. When you want to create a trail effect, set to a slower shutter speed.

P.PC_DMC-LX3_eng.book  55 ページ  ２００８年７月８日　火曜日　午後１０時１３分