Panasonic DMCLZ5S User Manual

Page of 112
Preparation
17
VQT0U87
2 Insert:
Insert the card fully until it clicks 
and it is locked.
Remove:
Push the card until it clicks, then 
pull the card out upright.
• Check the direction of the card.
• Do not touch the connection terminals 
on the back side of the card.
• The card may be damaged if it is not 
fully inserted.
Close the card door.
Slide the card door to the end 
and then close it firmly.
• If the card door cannot be completely 
closed, remove the card and insert it 
again.
• The card and the data may be damaged 
if it is inserted or removed while the 
camera is on.
• We recommend using Panasonic’s SD 
Memory Card.
About the Built-in 
Memory/the Card
∫ Built-in Memory [
]
You can record or play back pictures on 
the built-in memory when you are not 
using a card.
• The built-in memory capacity is about 
14 MB.
• Picture size is fixed to QVGA 
(320
k240 pixels) when recording 
motion pictures to the built-in memory. 
(P55)
∫ Card [
]
You can record or play back pictures on 
a card.
(The built-in memory cannot be used 
when a card is inserted.)
∫ Access to the built-in memory or the 
card
• The access indication lights red when 
pictures are being recorded on the built-in 
memory (or the card).
• Do not do the following when the access 
indication lights, pictures are being read or 
deleted or the built-in memory (or the 
card) is being formatted (P78).
– Turn the camera off.
– Remove the batteries or the card (if 
used).
– Shake or impact the camera.
– Disconnect the AC adaptor (DMW-AC6; 
optional). (when using the AC adaptor)
The card or the data may be damaged and 
the camera may not operate normally.
VQT0U87ENG.book  17 ページ  2005年12月27日 火曜日 午後7時12分