Panasonic DMCLZ5S User Manual

Others

92

VQT0U87

[MEMORY CARD ERROR
PLEASE CHECK THE CARD]
• An error has occurred accessing the card. 

Insert the card again.

• A card with a capacity more than 2 GB is 

inserted. Do not use a card with a 
capacity more than 2 GB.

[READ ERROR
PLEASE CHECK THE CARD]
An error has occurred reading the data.
Insert the card again. Make sure the card is 
inserted properly and then play back again.

[WRITE ERROR
PLEASE CHECK THE CARD]
An error has occurred writing the data.
Turn the camera off and remove the card. 
Insert the card again and turn the camera 
on. Make sure the camera is turned off 
before removing or inserting the card to 
avoid damage.

[MOTION RECORDING WAS 
CANCELLED DUE TO THE LIMITATION 
OF THE WRITING SPEED OF THE 
CARD]
• We recommend using a high speed SD 

Memory Card with “10MB/s” or greater 
displayed on the package when you set 
the picture quality to [30fpsVGA].

• Depending on the type of SD Memory 

Card, recording may stop in the middle.

[A FOLDER CANNOT BE CREATED]
A folder cannot be created because there 
are no remaining folder numbers that can 
be used. (P81)
Format the card after saving necessary 
data on a PC etc. (P78)

If you return the menu settings to the initial 
settings at the time of purchase, the 
condition may improve.
Select [RESET] in the [SETUP] menu. 
(P23)

∫ Batteries and the power source
1: The camera turns off immediately 

even when battery power is full.
The remaining battery power is low 
even if new batteries are inserted.
• The remaining battery power may not 

be displayed accurately, and the 
camera may suddenly stop working, 
when the type of battery and the 
settings on [BATTERY TYPE] are not 
identical. However this is not a 
malfunction. Depending on the battery 
brand and the operating temperature, or 
if exhausted batteries are used, the 
remaining battery power may not be 
displayed accurately.
– Please check [BATTERY TYPE] (P21) 

in the [SETUP] menu.

when it is turned on.
• Are the batteries inserted correctly?
• Use sufficiently charged batteries when 

using Ni-MH batteries.

camera is turned on.
• Is power save mode (P22) or economy 

mode (P22) activated?
– Press the shutter button halfway to 

cancel these modes.

• Are the batteries exhausted?

– Replace them with batteries which 

have sufficient capacity. (When you 
use Ni-MH batteries, charge them.)

after it is turned on.
• Are the batteries exhausted?

VQT0U87ENG.book  92 ページ  ２００５年１２月２７日　火曜日　午後７時１２分