Panasonic DMC LX 3 User Guide
49
VQT1T27
Advanced (Recording pictures)
∫ Shutter speed for each flash setting
¢1 It may vary depending on the [MIN. SHTR SPEED] setting
(P88)
.
¢2 When Intelligent ISO is set
(P78)
¢3 [SPORTS], [BABY1]/[BABY2] and [PET] in scene mode
(P62)
•
Refer to
P57
for the Aperture-priority AE, Shutter-priority AE or Manual exposure mode.
•
¢2, 3: The shutter speed becomes a maximum of 1 second in the following cases.
–
When the optical image stabilizer is set to [OFF].
–
When the camera has determined that there is little jitter when the optical image stabilizer is
set to [MODE1], [MODE2] or [AUTO].
set to [MODE1], [MODE2] or [AUTO].
•
In Intelligent auto mode, shutter speed changes depending on the identified scene.
•
There will be differences in the above shutter speeds in the scene modes.
–
[NIGHT PORTRAIT]/[NIGHT SCENERY]: 8 or 1/8th of a second to 1/2000th of a second
¢4
–
[CANDLE LIGHT]: 1 or 1/8th of a second to 1/2000th of a second
¢4
–
[FLASH BURST]: 1/30th of a second to 1/2000th of a second
–
[STARRY SKY]: 15 seconds, 30 seconds, 60 seconds
–
[FIREWORKS]: 1/4th of a second, 2 seconds
¢4
–
All other scene modes: 1/8th of a second to 1/2000th of a second
¢4 The maximum shutter speed is selected when the amount of jitter is minimal while
[STABILIZER] is set or when [STABILIZER] is set to [OFF].
Note
•
Do not bring the flash too close to objects or close the flash while it is activated. The
objects may be discolored by its heat or lighting.
objects may be discolored by its heat or lighting.
•
Do not close the flash soon after the flash is activated prior to taking pictures due to AUTO/
Red-eye reduction etc. It causes a malfunction.
Red-eye reduction etc. It causes a malfunction.
•
When you take a picture beyond the available flash range, the exposure may not be adjusted
properly and the picture may become bright or dark.
properly and the picture may become bright or dark.
•
When the flash is being charged, the flash icon blinks red, and you cannot take a picture even
when you press the shutter button fully.
when you press the shutter button fully.
•
The white balance may not be properly adjusted if the flash level is insufficient for the subject.
•
When the shutter speed is fast, the flash effect may not be sufficient.
•
It may take time to charge the flash if you repeat taking a picture. Take a picture after the
access indication disappears.
access indication disappears.
•
The red-eye reduction effect differs between people. Also, if the subject was far away from the
camera or was not looking at the first flash, the effect may not be evident.
camera or was not looking at the first flash, the effect may not be evident.
•
When the [CONVERSION]
(P90)
is set to [
], the flash is fixed to [Œ].
•
When the external flash is installed, it will be prioritized. See
P121
for more information on the
external flash.
[REC] mode:
Taking Close-up Pictures
This mode allows you to take close-up pictures of a subject, e.g. when taking pictures of
flowers. You can take pictures of a subject as close as 1 cm (0.04 feet) from the lens by
rotating the zoom lever upmost to Wide (1
flowers. You can take pictures of a subject as close as 1 cm (0.04 feet) from the lens by
rotating the zoom lever upmost to Wide (1
k).
Flash setting
Shutter speed (Sec.)
Flash setting
Shutter speed (Sec.)
‡
1/30
¢1
to 1/2000th
1 to 1/2000th
1 or 1/4th to 1/2000th
1 or 1/4th to 1/2000th
¢2
‰
Œ
1
¢1
to 1/2000th
1 or 1/4th to 1/2000th
¢2, 3
P.PC_DMC-LX3_eng.book 49 ページ ２００８年７月８日 火曜日 午後１０時１３分