Panasonic DMC-FZ4PP User Manual

Page of 128
Before Use
4
VQT0Q09
∫ Care for the camera
• Do not shake or cause impact to the 
camera. The camera may not be 
operated normally or recording of pictures 
may be disabled, or the lens may be 
damaged.
• Sand or dust may cause a malfunction 
of the camera. When you use the 
camera on a beach etc., take care so 
that sand or dust does not get into the 
camera.
• When you use the camera on a rainy day 
or on a beach, take care so that water 
does not get into the camera.
• If seawater splashes onto the camera, 
wet a soft cloth with tap water, wring it 
well, and use it to wipe the camera 
body carefully. Then, wipe it again with 
a dry cloth.
∫ About the LCD monitor/Viewfinder
• Do not press the LCD monitor strongly. 
It may cause uneven colors on the LCD 
monitor or a malfunction of the LCD 
monitor.
• In a place with drastic temperature 
changes, condensation may form on the 
LCD monitor. Wipe it with a soft, dry cloth.
• If the camera is extremely cold when you 
turn the camera on, the image on the LCD 
monitor/Viewfinder is slightly darker than 
usual at first. However, as the internal 
temperature increases, it goes back to the 
normal brightness. 
∫ About the Lens
• Do not direct the lens to the sun or strong 
light sources. It may cause not only a 
malfunction of the camera but irreversible 
damage to your eye.
• Do not press the lens strongly.
• Leaving the camera with the lens facing 
the sun may cause a malfunction. Be 
careful when you put the camera outside 
or near a window.
∫ About Condensation (When the lens 
or the Viewfinder is fogged up)
Condensation takes place when the 
ambient temperature or humidity is 
changed as follows:
Be careful of condensation since it causes 
stains on the lens, fungus or malfunction.
• When the camera is brought inside from 
the cold to a warm room.
• When the camera is moved from outside 
to an air-conditioned car.
• When cool wind from an air conditioner or 
other is directly blown onto the camera.
• In humid places
Put the camera into plastic bag until the 
temperature of the camera is close to the 
ambient temperature to avoid 
condensation. In case of condensation, 
turn the camera off and then leave it for 
about 2 hours.
When the camera becomes close to the 
ambient temperature, the fog disappears 
naturally.
Extremely high precision technology is 
employed to produce the LCD monitor/
Viewfinder screen. The result is more 
than 99.99% effective pixels with a 
mere 0.01% of the pixels inactive or 
always lit. However, this will not be 
recorded on the pictures in the card.
VQT0Q09ENG.book  4 ページ  2005年1月25日 火曜日 午後8時17分