Panasonic 75/85/95 MXP User Manual

16 

 

 
Wake up the system 
 
When the system is not in use, it is in standby mode and the screen(s) are black. Wake up the 
system by picking up the remote control. An incoming call or pressing any key on the remote 
control will also wake up the system. 
 
If the system does not respond: 
 

ƒ 

 

Make sure that the system is switched on by using the On/Off switch located at the rear 

of the Codec.  

ƒ  Verify that your monitor is switched on. This is normally done by pushing the power 

button on the front of the monitor depending on monitor type.