Oregon Scientific ATC5K User Manual

The camera can be mounted in a number of ways using the straps and the velcro patch
provided. Please follow the methods of mounting as suggested below:

a) With the base of the camera facing you, turn the clip 

clockwise to tighten its position.

b) With the base of the camera facing you, turn the clip 

counter clockwise to loosen its position.

1. Attach the rubberised patch to the bottom of the helmet mount grip.

2.+3. Thread the silicon rubber strap through the helmet grip.

4. Mount the helmet grip to the helmet using the silicon rubber strap.
5. Slide the camera into the helmet mount grip.

6. Adjust the angle of the camera making sure it's secure.

7. If the camera seems loose when the helmet is moved use the velcro patches to 

secure it against the helmet.

8. To avoid damage to the camera, the mount lock at the base must be loosened  

before twisting the camera.

1. Attach the rubber patch to the bottom of the helmet grip.

2+3. Place the helmet grip on the helmet, and thread the velcro strap through the helmet grip.

4. Secure the velcro strap by fastening 

it through the helmet vents.

5. Slide the camera into the helmet 

mount grip, and adjust the angle of
the camera making sure it is secure.

Note: Use caution
when twisting; the
clip may be sharp.

#1

#2

#3

#4

#5

#6

#1

#2

#3

#4

#5

1. Place the handlebar grip on the handlebar.
2. Add the screw and nut to hold the handlebar    

grip securely.

3. Slide the camera into the handlebar grip and    

make sure the handlebar grip is locked  
with the camera.

4. Adjust the angle of the camera.

1. Attach the tripod mount to the bottom of the    

camera.

2. With the tripod mount on the camera, screw 

it onto the webcam stand.

3. Adjust the angle of the camera.

#1

#2

#3

#4

When opening the cover make sure the clip is in 
the same direction as the lens. Observe the following 
precautions when opening the end of the camera:
1. Unlock the rear of the unit by squeezing the black 

release buttons whilst lifting the latch.

2. Use a coin or screwdriver to turn the screw anti-   

clockwise to release the battery door.

3. Insert 2 x AA alkaline batteries into the battery slot

with the polarity in the direction as shown.

4. Close the battery slot door and ensure the screw is tight

before closing and locking the latch.

Note: When the battery is low, the low battery icon will
appear on the LCD screen. Please ensure you save your 
recording and then change the old batteries for new ones.

Note:
a) Do not mix old and new batteries together. Replace both batteries at the

same time.

b) Remove the batteries if the camera is not going to be used for extended

periods of time. 

c) Do not mix alkaline, standard (carbon-zinc) or rechargeable

(nickel-cadmium) batteries. Only batteries of the same or equivalent
type as recommended are to be used together.

d) Do not touch the flat cable at the back of the camera.

(1)

(2)

(3)

EN

ATC5K_manual_UK0827.qxd  9/2/08  10:09 AM  Page 5