Kodak DCS Pro SLR/n User Manual

You can change the strength of a lens in the user list two ways:

• Reset the lens to factory defaults (see 

). (This feature is 

available only for lenses that were in the master list.)

• Determine the optimum strengths using Photo Desk, (see 

then assign the strengths to the camera (see 

Do the following when you are changing the strengths of a lens in the user 
list or when you are using the Manual method (see 

):

1. Capture an image of a gray card at normal exposure. (Fill the frame 

with the gray card.)

2. On your computer, open the image in Photo Desk. 

If the lens optimization strength is too low, the corners of the image 
appear green or yellow.

If the lens optimization strength is too high, the corners of the image 
appear blue or magenta.

3. In Photo Desk, use Click Balance at the center of the image.

4. Click Lens Optimization, then adjust the slider to make the corners 

neutral. The number for the appropriate strength appears. Click OK.

5. Make a note of this number so you can assign it to the lens 

(see 

6. Repeat steps 1 - 5 for all combinations of minimum/maximum focal 

length, and minimum/maximum aperture.

NOTE:  Refer to the Help for Photo Desk for more information.