Zebra Technologies radio frequency identification (rfid) User Manual
103
ZPL II Commands for RFID
~RO
11/14/2008
RFID Programming Guide
58978L-008 Rev. A
~RO
Reset Advanced Counters
Description The
~RO
command resets the advanced counters used by the printer to monitor
label generation in inches, centimeters, and number of labels.
Format ~ROc
This table identifies the parameters for this format:
Important •
This command is not supported by all printers or firmware. See
for the list of printers and firmware with which you can
use this command.
Note •
For the R4Mplus, the counter values are not saved, so power cycling the printer resets
all counters to zero.
Parameters
Details
c
=
counter number
Accepted Values:
1
= reset counter 1
2
= reset counter 2
3
= reset valid RFID label counter
4
= reset voided RFID label counter
R =
reset head replaced counter
(R
(R
resets the head cleaned counter and the head
replaced counter.)
C =
reset head cleaned counter
Default Value: a value must be specified or the command is
ignored
ignored
Example 1 •
This example shows how the counter portion of the printer configuration labels
looks when counter 1 is reset by sending
~RO1
.
Before
After