Zebra Technologies TTP 2000 User Manual
101
Page setup
Aligning Preprint and Thermal Print
09/14/2009
TTP 2000 Technical Manual
P1002902-002
Aligning Preprint and Thermal Print
The printer can synchronize the cutting of the printout with black-marks printed on the back of
the paper. You use this function when you have preprint on the printout and you don't want a
cut in the middle of that preprint, or text printed on top of the preprint.
the paper. You use this function when you have preprint on the printout and you don't want a
cut in the middle of that preprint, or text printed on top of the preprint.
Figure 30 • Black Mark Sensor
The sensor used to detect the black-marks is the same sensor as used for paper end detection.
The sideways position depends on which paper guide is fitted. With 58 and 60 mm guides it is
22 mm to the left of the paper center, and with 80 and 82.5 mm guides, it is 30 mm to the right
of the paper center. The distance from the sensor to the cutter is 25 mm. The sensor accuracy is
about ±0.5 mm so avoid designing receipts with too high demands for synchronization.
The sideways position depends on which paper guide is fitted. With 58 and 60 mm guides it is
22 mm to the left of the paper center, and with 80 and 82.5 mm guides, it is 30 mm to the right
of the paper center. The distance from the sensor to the cutter is 25 mm. The sensor accuracy is
about ±0.5 mm so avoid designing receipts with too high demands for synchronization.
Black-mark on
back of paper
back of paper
Black-mark and
paper-out sensor
paper-out sensor