Zebra Technologies TTP 2000 User Manual
107
Page setup
Parameters Used
09/14/2009
TTP 2000 Technical Manual
P1002902-002
Manual Cut-Offset
If set to 1 and above, the auto offset is turned off and you must measure the offset from the
actual sensor position that is 25 mm before the cutter.
actual sensor position that is 25 mm before the cutter.
(ESC x n1 n2 is an obsolete command that sets n41 and n42. It is implemented for backward
compatibility with old drivers. Set parameters n41 and n42 with the
ESC & P n1 n2 command instead.)
compatibility with old drivers. Set parameters n41 and n42 with the
ESC & P n1 n2 command instead.)
FF (Form Feed)
Use FF to print the buffer content, go to the next top of form (black mark), and cut the paper.
n41 & n42
The actual cut position
Desired cut position
Black mark detected