Zebra Technologies TTP 2000 User Manual
59
Programming
Software Command Syntax
09/14/2009
TTP 2000 Technical Manual
P1002902-002
System Related Commands
<ESC>?
restarts the printer with a complete reset. During this operation, all buffers are
purged, all memory is cleared, and stored parameters are reloaded. USB printers will go off the
bus during execution of this command and will reconnect when the reset is complete. After
issuing this command, wait approximately 3 seconds for the printer to reset before issuing data
to the printer.
bus during execution of this command and will reconnect when the reset is complete. After
issuing this command, wait approximately 3 seconds for the printer to reset before issuing data
to the printer.
<ESC>@
terminates command processing and reinitializes the control board. All parameters
are set to power on values and all buffers are purged. After issuing this command, wait
approximately 3 seconds for the printer to reset before issuing data to the printer.
approximately 3 seconds for the printer to reset before issuing data to the printer.
<ESC>&<1>
stores a logotype bitmap in the flash PROM. The logotype is stored to flash
memory and the printer is reset. The logotype can then be printed with <ESC>g and <ESC>L
commands, see
commands, see
and
. Also see
. The printer indicates that storage is complete by operating the presenter motor for
a short period of time.
<ESC>&<L>
erases all logotypes stored in the flash PROM. The printer indicates that erasure
is complete by operating the presenter motor for a short period of time.
<ESC>&<4>
stores the current setting of all parameter values in the printer’s flash memory.
These parameters are then used as default power on parameters. Storing the parameters to flash
memory takes approximately 4 seconds, during which time the printer cannot communicate.
The printer indicates that storage is complete by operating the presenter motor for a short
period of time.
memory takes approximately 4 seconds, during which time the printer cannot communicate.
The printer indicates that storage is complete by operating the presenter motor for a short
period of time.
ESC ?
Reset (Full)
1B 3F
Hex
27 63
Decimal
ESC @
Reset (Initialize)
1B 40
Hex
27 64
Decimal
ESC & 1
Load Logotype
1B 26 01
Hex
27 38 1
decimal
Note •
The Toolbox application can be used to load new firmware.
ESC & L
Erase All Logotypes
1B 26 4C
Hex
27 38 76
decimal
ESC & 4
Store Current Parameter Values
1B 26 04
Hex
27 38 4
decimal