Fujitsu C150-E049-02EN User Manual

By the operator panel you can set following conditions. Other
conditions such as print offset, print characters can be set by the host
machine.

When you use the endorser, you must set the endorser ON as follows.

1 While pressing the [Mode 1], turn on the

power of the scanner. Then the LCD
displays the SETUP MODE initial
screen. (Screen 1)

2 Press [Mode 1] eight times to go to the

ENDORSER INITIAL screen. (Screen 2)
Then press [Mode 2]. If “ON” is
displayed, the endorser is already on.
(Screen 3)

3 If “OFF” is displayed, press [Mode 1],

until “OFF” blinks. Then press [Mode 2]
to turn the endorser ON. (Screen 3)

If you want to set the status in EEPROM,
go to 5 . Then if you want to close the job,
go to 6  and 7 .

NOTICE: Set the endorser ON only when you use endorser, or the

Initial number is the number which the scanner starts printing or
returns after the reset of print number.

4 At Screen 3, press the [Mode 1] until the

digit you want to changes blinks. Then
press [Mode 2] until the digit changes as
you want. (Screen 4: In this case the
initial number is five.)

<< SETUP MODE >>

ENDORSER

VALUE

* ON

0 0 0 0 1

<< SETUP MODE >>

ENDORSER  INITIAL

Screen 2

Screen 3

Screen 1

ENDORSER

VALUE

* ON

0 0 0 0 5

Screen 4