Teledyne 703E User Manual

 

The M703E can be connected to a modem for remote access.  This requires a cable between the calibrator’s 
COM port and the modem, typically a DB-9F to DB-25M cable (available from Teledyne Instruments with part 
number WR0000024). 

Once the cable has been connected, check to make sure:  

  The DTE-DCE is in the DCE position.  
  The M703E COM port is set for a baud rate that is compatible with the modem,  
  The Modem is designed to operate with an 8-bit word length with one stop bit. 
 The MODEM ENABLE communication mode is turned ON (Mode 64, see Section 7.1.4).   

Once this is completed, the appropriate setup command line for your modem can be entered into the calibrator.  
The default setting for this feature is 

This string can be altered to match your modem’s initialization and can be up to 100 characters long. 

To change this setting press: 

STANDBY            ACT =STANDBY

<TST

TST>

GEN STBY SEQ

SETUP X.X        

O3

SEQ CFG CLK PASS

EXIT

SETUP X.X        

VARS DIAG

EXIT

SETUP X.X        

ID

COM2

EXIT

SETUP X.X        

EDIT

EXIT

SETUP X.X        

Continue pressing <SET or SET> until ...

SETUP X.X        

EXIT discards the 

new setting

ENTR accepts the 

new setting

The <CH and CH>

keys move the cursor 

left and right along the 

text string

The INS and CH> key 

inserts a new 

character before the 

cursor position

The DEL

deletes 

character at 

the cursor 

position

Toggle this key to cycle through the 

available character set: 

Alpha: A-Z (Upper and Lower 
Case);   
Special Characters: space ’  ~ !  # $ 
% ^ & * ( ) - _ = +[ ] { } < > | ; : , . / ? 
Numerals: 0-9