Teledyne 703E User Manual

There are several circumstances when you may need to configure the interface settings of the calibrator’s 
Ethernet card manually.  The 

INET sub-menu may also be used to edit the Ethernet card’s configuration 

properties   

  Your LAN is not running a DHCP software package, 
  The DHCP software is unable to initialize the calibrator’s interface; 
  You wish to program the interface with a specific set of IP addresses that may not be the ones 

automatically chosen by DHCP. 

Editing the Ethernet Interface properties is a two-step process.   

STEP 1: Turn DHCP OFF:   While DHCP is turned ON, the ability to set INSTRUMENT IP, GATEWAY IP and 

SUBNET MASK manually is disabled 

ID ADDR

EXIT

<SET SET>

EXIT

ENTR EXIT

Toggle this key 

to turn

ENTR accepts 

the new setting

EXIT ignores the 

new setting

Continue to Step 2 Below

STANDBY            ACT =STANDBY

<TST

TST>

GEN STBY SEQ

SETUP X.X        

O3

SEQ CFG

CLK PASS

EXIT

SETUP X.X        

VARS DIAG

EXIT