Fujitsu FI-6230Z User Manual
Chapter 9 Operational Settings
185
Specifying an Area Not to Detect Multifeed
[Intelligent Multifeed Function]
[Intelligent Multifeed Function]
When there is paper of the same size attached to a
designated location on the page, the scanner memorizes the
location of the attachment and can be configured not to detect
multifeeds for that location. Note that you first need to select
[Check Overlapping (Ultrasonic)] or [Check Overlapping and
length] in either the scanner driver’s setup dialog box or the
multifeed detection setting in
designated location on the page, the scanner memorizes the
location of the attachment and can be configured not to detect
multifeeds for that location. Note that you first need to select
[Check Overlapping (Ultrasonic)] or [Check Overlapping and
length] in either the scanner driver’s setup dialog box or the
multifeed detection setting in
1
Start up the Software Operation Panel.
.
2
From the listing on the left, select [Device Setting 2] J
[Intelligent Multifeed Function].
[Intelligent Multifeed Function].
3
Select an operation mode and click the [OK] button.
.
Mode
Description
Manual mode
Does not memorize the size or location of the
paper attachment when a multifeed is detected.
Ignores the multifeed when you load the
documents back in the ADF paper chute and
scan them again.
paper attachment when a multifeed is detected.
Ignores the multifeed when you load the
documents back in the ADF paper chute and
scan them again.
Auto mode 1
Memorizes the size and location of the paper
attachment when a multifeed is detected. The
memorized pattern is ignored from the next
scan.
attachment when a multifeed is detected. The
memorized pattern is ignored from the next
scan.
Auto mode 2
Memorizes the size of the paper attachment
when a multifeed is detected. The memorized
pattern (including any length less than the
attachment) is ignored from the next scan.
when a multifeed is detected. The memorized
pattern (including any length less than the
attachment) is ignored from the next scan.
z
By selecting the [Clear overlap pattern] check box, you
can erase the overlapping patterns (length, position)
that were memorized in Auto mode.
can erase the overlapping patterns (length, position)
that were memorized in Auto mode.
z
In [Remember multifeed pattern at power-off], you can
select whether or not to keep the multifeed pattern
upon turning the power off. When [Remember] is
selected, you can use eight (pages worth) of the most
recent patterns the next time the scanner is powered
on.
select whether or not to keep the multifeed pattern
upon turning the power off. When [Remember] is
selected, you can use eight (pages worth) of the most
recent patterns the next time the scanner is powered
on.