Epson StylusPro10000 User Manual

6. Have four people lift the printer unit off of the leg assembly, using the 

hand grips located at the four corners of the printer. Lift the back of the 
printer first, tilt it slightly to the front, then slide it back to remove it.

7. Keep the printer level while you move it. 

Setting up the printer after transporting it is almost identical to setting it up 
for the first time. Whenever you set up the printer, see the Unpacking and 
Assembly Guide, and note the following points:

•

Don’t forget to remove any protective material (such as tape from the 
ink cartridge clamps).

•

The first time you start printing after moving the printer, the print head 
nozzles may be clogged. You may need to run a cleaning cycle (see 
page 6-1) and realign the print head (see page 6-4) to ensure good print 
quality. 

When you need to move the printer a short distance, such as within the same 
building or facility, you can roll the printer on its casters. Follow these steps:

1. Make sure that the power cord, interface cable, roll paper spindles and 

sheet media are removed, and the roll paper cover and lower cover are 
closed.

The printer unit weighs 
approximately 291 lb 
(132 kg). Always have four 
people lift it, using the hand 
grip areas as shown.

Do not roll the printer 
on angled or uneven 
surfaces.