Epson StylusPro10000 User Manual
2-13
Handling Paper and Other Media
|
2-13
8. Push the paper set lever all the way in, then close the lower cover.
PRESS PAUSE BUTTON
appears on the control panel display.
9. Press the Pause button. The print head moves and the board feeds into
printing position automatically. READY appears on the control panel.
(Even if you don’t press Pause, the board and printer will move into
printing position automatically after 10 seconds.)
(Even if you don’t press Pause, the board and printer will move into
printing position automatically after 10 seconds.)
10. Run your print job. After it is finished, the posterboard stays in the
printer.
11. To remove the print, hold it and pull the paper set lever all the way out.
Adjusting the Platen Gap for Heavy Stock
When you print on heavy stock, you may need to adjust the platen gap
setting. Normally, the AUTO setting allows the printer to adjust
automatically. However, if print quality is not satisfactory when you use
heavy stock, change this setting to WIDE. Follow these steps:
setting. Normally, the AUTO setting allows the printer to adjust
automatically. However, if print quality is not satisfactory when you use
heavy stock, change this setting to WIDE. Follow these steps:
1. Press the SelecType button. PRINTER SETTING MENU appears on
the display.
2. Press the Item button. PLATEN GAP=AUTO appears on the display.
3. Press the + button. PLATEN GAP=WIDE appears on the display.
Caution
To avoid damaging the
printer, never move the
paper set lever while the
Operate or Pause light
is flashing.
printer, never move the
paper set lever while the
Operate or Pause light
is flashing.