Epson Photo 925 User Manual

❏ If you use an extension cord with the printer, make sure that 

the total ampere rating of the devices plugged into the 
extension cord does not exceed the cord’s ampere rating. Also, 
make sure that the total ampere rating of all devices plugged 
into the wall outlet does not exceed the wall outlet’s ampere 
rating.

❏ Do not attempt to service the printer yourself.

❏ Unplug the printer and refer servicing to qualified service 

personnel under the following conditions:

The power cord or plug is damaged; liquid has entered the 
printer; the printer has been dropped or the cabinet damaged; 
the printer does not operate normally or exhibits a distinct 
change in performance.

❏ If you plan to use the printer in Germany, the building 

installation must be protected by a 10 or 16 amp circuit 
breaker to provide adequate short-circuit protection and 
over-current protection for this printer.

Observe the following when choosing a place for the printer:

❏ Place the printer on a flat, stable surface that extends beyond 

the printer base in all directions. If you place the printer by 
the wall, leave more than 10 cm between the back of the 
printer and the wall. The printer will not operate properly if 
it is tilted at an angle.

❏ When storing or transporting the printer, don't tilt it, stand it 

on its side or turn it upside down. Otherwise ink may leak 
from the cartridge.

❏ Leave enough space in front of the printer for the paper to be 

fully ejected.