Panasonic MW-20 User Manual

VQT2Z87

The specifi c setting is required to use the main unit in a 
wall-mounted state. Make the wall-mount settings on the 
menu and install it on the wall.

Do not install this unit at the following locations to ensure 
this unit’s performance and to prevent potential troubles.
–  Locations other than vertical walls
–  Locations near a sprinkler or a sensor
–  Locations near high-voltage lines or power sources
–  Locations where wind from a heating device hits the unit
–  Locations where the unit is subject to vibration or 

impact

–  Locations near sources of magnetism, heat, vapor, oil 

smoke, etc.

–  Locations of high temperature, such as near ceiling 

lights (spotlight, halogen light, etc.)

–  Locations where there may be water droplet (i.e. under 

an air conditioner)

–  High places where the SD insertion part cannot be 

reached easily

Use a proper installation method that suits the structure 
and material of the installing location.
Use a cloth, etc. to prevent damage of the product or 
fl oor during installation.
When tightening screws, make sure the screws are not 
loosely-tightened or overtightened.
Secure safety in the surrounding areas and pay enough 
attention during installation.

z

z

z

z

z

Prepare commercially available screws that match the screw 
holes of the unit’s bottom face.

5 mm (13/64")

11 mm (7/16")

Screw hole on the main 
unit’s bottom face

2 screws for wall-mounting
2 screws for the fi tting for wall-mounting

A length which supports the strength of 5 kg (11.1 lb.) or 
more must be kept for each screw.

At least 30 mm (1

3

/

16

")

(5/32")

4 mm

7.4 mm (19/64") to 9.4 mm (3/8")

2.2 mm (3/32") to 3 mm (1/8")

3 mm (1/8") to 4 mm (5/32")

Use commercially available screws with the nominal 
diameter of 4 mm (5/32") or equivalent which are suitable for 
materials of the wall (i.e. wood, steel, concrete, etc.) 

„

•
•

Panasonic is not liable for incidental or consequential 
damages resulting from improper installation or operation.
Keep the screws out of reach of children to prevent swallowing.

1. Press [MENU].
2. Press [e, r, w, q] to select “Settings Menu” and 

3. Press [e, r, w, q] to select “Wall-mount Setting” 

4. Press [e, r] to select “Yes” and press [OK].

Wall-mount Setting  

Select Item  

OK 

No 

Yes 

Selecting “Yes” will rotate the display by 180 degrees. 
The main unit controls cannot be used in this mode.  

5. Press [w, q] to select “Yes” and press [OK].

The power will be turned off and on automatically.
When the power is turned on, the main unit’s screen 
display is turned upside down.

The audio will be stopped (paused) automatically, during 
playback.

The following buttons and functions that can be used will be 
restricted.

Except [POWER 

8]

[iPod/PLAY MENU]
[iPod/DISPLAY]
[iPod/

q/h]

•
•
•

Automatically disabled (with the 
setting contents preserved)

“iPod Play/Pause”
“iPod Display”
“iPod Play Menu”
“Audio Menu”
“Sync Music” in the “Photo 
Playback Settings”

•
•
•
•
•

Automatically turned off

Automatically disabled

Cannot be used

Cannot be used

•

•

•

„