Panasonic AJ-P2C004HG User Manual
62
Adjustments and Settings for Recording: Setting Time Data
The user bits (UB) to be recorded in the sub-code area are
selected through the menu option UB MODE. The user bits
(VITC UB) to be recorded in the VIDEO AUX area are
selected through the menu option VITC UB MODE.
selected through the menu option UB MODE. The user bits
(VITC UB) to be recorded in the VIDEO AUX area are
selected through the menu option VITC UB MODE.
USER (UB MODE only)
The included user value is recorded. A user value is
input through the display window. For more information
about how to input a user value, see [Inputting a user
value] (page 62). The recorded user value is retained
even if the power is turned off.
input through the display window. For more information
about how to input a user value, see [Inputting a user
value] (page 62). The recorded user value is retained
even if the power is turned off.
TIME
The time kept by the built-in clock is recorded.
DATE
The hour digits for date and time kept by the built-in
clock are recorded.
clock are recorded.
EXT (UB MODE only)
The user bits value input through the TC IN connector is
recorded.
The included user’s value will also be this input value.
recorded.
The included user’s value will also be this input value.
TCG
The time code value is recorded.
FRM RATE
The frame rate information for camera shooting is
recorded. For more information, see [Frame rate
information recorded in user bits] (page 63).
recorded. For more information, see [Frame rate
information recorded in user bits] (page 63).
REGEN
The user bits last recorded on the current target P2 card
is read and recorded as is.
is read and recorded as is.
USER/EXT (VITC UB MODE only)
The included user’s value is recorded as the user bits
for the VIDEO AUX area. It is the same value as the
user bits indicated when the option UB MODE is set to
“USER” or “EXT”.
for the VIDEO AUX area. It is the same value as the
user bits indicated when the option UB MODE is set to
“USER” or “EXT”.
a. HOLD switch
b. DISPLAY switch
c. Display window
d. TCG switch
e. Cursor and SET buttons
b. DISPLAY switch
c. Display window
d. TCG switch
e. Cursor and SET buttons
1
Position the DISPLAY switch at [UB].
2
Position the TCG switch at [SET].
When the left digit starts blinking you can change the
value.
When the left digit starts blinking you can change the
value.
3
Use cursor buttons to set the user bits.
Z button:
Shifts the target (blinking) digit to the right.
Y button:
Shifts the target (blinking) digit to the left.
U button:
Advances the blinking number by one digit.
V button:
Winds back the blinking number by one digit.
4
Position the TCG switch at [F-RUN] or [R-RUN].
5
Go to the <TC/UB> screen from the MAIN OPERATION
page, and set the menu option UB MODE to “USER”.
page, and set the menu option UB MODE to “USER”.
Notes
When the TCG switch is positioned at [SET], thumbnails
cannot be manipulated.
To confirm VITC UB, press the HOLD switch to display
VTCG on the display window.
cannot be manipulated.
To confirm VITC UB, press the HOLD switch to display
VTCG on the display window.
Setting of the user bits
Inputting a user value
a
b
c
d
e
AJ-HPX2700G-VQT1V27_eng.book 62 ページ ２００８年９月２日 火曜日 午後５時４３分