Sony HKCU-904 User Manual

1-12 (E)

HDCU-900 MM

After replacing each plug-in board, return the switches to
the setting before replacement. Also, readjust and reset the
following items.

While referring to Section 2, “System Setup” of the
separate Installation and Maintenance Manual, readjust and
reset the following items.

Adjustment and setting items
2-2-1. Setting the Intercom System

. Selecting the intercom system
. Setting the input level of the PGM audio signal
. Selecting an intercom line to be connected to the

INTERCOM connector

2-2-2.

Setting the Microphone

. Controlling the microphone input level from the

remote control

. Adjusting the microphone input level using the

MIC LEVEL switch

. Setting the microphone output level

2-3-1.

Setting the Tally System

2-3-2.

Setting the Camera Number

2-4-2.

Adjusting the Signal Phase

. Adjusting the sync signal phase

While referring to Section 2, “System Setup” of the
separate Installation and Maintenance Manual, readjust and
reset the following items.

Adjustment and setting items
2-4-4. Adjusting the Level of Signals for Waveform

Monitor
. Adjusting the staircase signal

If required, adjust the following items too.
2-4-4. Adjusting the Level of Signals for Waveform

Monitor
. Adjusting the WF Output Signal Level

2-4-5. Adjusting the Level of Signals for Picture Monitor

While referring to Section 3, “Electrical Alignment”,
adjust the following item.

Adjustment item
3-3-3. Clock (74 MHz) Duty Adjustment/DPR Board

(Board suffix: -14 only)

3-3-4. Prompter Level Adjustment

While referring to Section 3, “Electrical Alignment”,
adjust the following items.

Adjustment items
3-5-4. GRB Output Level Adjustment
3-5-6. Return Level Adjustment

While referring to Section 2, “System Setup” of the
separate Installation and Maintenance Manual, adjust the
following item.

Adjustment item
2-4-3. Level Adjustment of the VBS Signal

1-5. Adjustment and Setting after Replacing the Boards