Panasonic SDR-H80 User Manual

Page of 32
13
(ENG) LSQT1467
The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always 
“live” as long as the AC adaptor is connected to an electrical outlet.
Important:
While the DC cable is connected to the AC adaptor, the battery will not charge.
1
Connect the AC cable to the AC 
adaptor and the AC outlet.
2
Connect the DC cable to the AC 
adaptor.
3
Connect the DC cable to this unit.
≥ Do not use the AC cable with any other 
equipment as it is designed only for this unit. 
Also, do not use the AC cable from other 
equipment with this unit.
Battery capacity indication
≥ The display changes as the battery capacity reduces. 
#
#
#
#
If there is less than 3 minutes remaining, then 
 will become red. If the battery discharges, 
then (
) will flash.
≥ The remaining battery capacity is displayed when using the Panasonic battery that you can use for 
this unit. It may take time to display the remaining battery capacity. The actual time can vary 
depending on your actual use.
≥ The maximum amount of remaining battery capacity able to be indicated is 9 hours 59 minutes. If 
the actual remaining time exceeds 9 hours 59 minutes, the indication will stay green and will not 
change until the remaining time falls below 9 hours 59 minutes.
≥ When turning the mode dial to switch modes, the time indication will turn off momentarily in order to 
recalculate the remaining battery capacity time.
≥ When using the AC adaptor or batteries made by other companies, the remaining battery capacity 
will not be shown.
Connecting to the AC outlet
SDR-H90&80EP-LSQT1467_mst.book  13 ページ  2008年12月2日 火曜日 午後2時32分