Panasonic NV-DS65 User Manual

Page of 60
14
Using the Menu Screen
To facilitate the selection of a desired function or setup, this 
Movie Camera displays various function setups on Menus.
1
Press the [MENU] Button.
≥The Menu corresponding to the Mode selected by using 
the [VCR/OFF/CAMERA/M-CARD] Switch 
1
 is displayed.
2
Turn the [PUSH] Dial to select a desired 
Sub-Menu.
≥Turn the [PUSH] Dial to display the highlightened item.
3
Press the [PUSH] Dial to display the selected 
Sub-Menu.
4
Turn the [PUSH] Dial to select the item to be set.
5
Press the [PUSH] Dial to set the selected item to a 
desired mode.
≥With each pressing of the [PUSH] Dial, the cursor [1] 
moves to the next mode.
≥While a Menu is displayed, you cannot record or play back. 
Menus can be displayed during playback but not during 
recording. The above operations can be done using the 
[MENU] Button, [SET] Button and [ITEM] Button on the 
Remote Controller. (
To Exit the Menu Screen
Press the [MENU] Button again.
About the Menu Mode Setting
The setting selected on the Menu will be retained even when the 
Movie Camera is turned off. (But, the setups of 
[DIGITAL EFFECT] are not retained.) However, if the Battery or 
AC Adaptor is disconnected before turning off the Movie 
Camera, the selected setup may not be retained.
≥Menu operation flow is shown in this text by >>.
ª Image Selection in the Card Playback Mode 
(NV-DS65 only)
 (
An Image Selection Operation may be necessary during Menu 
Operations. In this case, carry out the following procedure.
1
Turn the [PUSH] Dial and select a picture.
≥The selected picture is underlined 
2
.
2
Press the [PUSH] Dial to confirm the selection of 
the picture.
≥After the above Picture Selection Procedure, carry out the 
various Menu Operations. (The above procedure will not be 
repeated in the following instructions.)
2
1, 2
DELETE:M-DEL  D-000
PRESS STOP TO EXIT
1
2
3
4
5
6
PUSH
SHUTTER / W B / IRIS/ MF / JOG
1
2, 3, 4, 5
1
M ENU
PUSH
SHUTTER / W B / IRIS/ MF / JOG
EG-ENG.book  14 ページ  2003年1月6日 月曜日 午後3時43分