Panasonic NV-GS35GN User Manual

Page of 56
Before using
16
LSQT0893
ª
Selecting the remote control mode
If 2 cameras are used simultaneously, set the 
mode for one pair of movie camera and remote 
control to [VCR1] and that of the other pair to 
[VCR2]. This will prevent interference between 
the 2 pairs. (The default setting is [VCR1]. When 
the button-type battery is replaced, the setting will 
revert to the default [VCR1].) 
1
Setting on the camera:
Set [SETUP] >> [REMOTE] >> [VCR1] or 
[VCR2].
2
Setting on the remote control:
[VCR1]:
Press [
D] and [] simultaneously. 1
[VCR2]:
Press [
E] and [] simultaneously. 2
ª
Concerning the button-type battery
≥When the button-type battery runs down, 
replace it with a new battery (part number: 
CR2025). The battery is normally expected to 
last about 1 year, but it depends on operation 
frequency.
≥Keep the button-type battery out of the reach of 
children.
≥If the remote control mode of the camera and 
that of the remote control do not match with 
each other, “REMOTE” will appear. When the 
remote control is operated for the first time after 
the camera is turned on, “CHECK REMOTE 
MODE” (
-43-
) will appear and operation is 
impossible. Set the same remote control mode.
≥The remote control is intended for indoor 
operation. Outdoors or under strong light, the 
movie camera may not operate properly even 
within the usable ranges.
Free style remote control
This controller can be used from different high 
and low angles. It is also handy when a tripod is 
used. When you do not use the controller, attach 
the clip to the grip belt. Left-handed users can use 
this camera more easily.
(1)
Recording start/stop button [REC]
(2)
Zoom lever [W/T]
(3)
Photoshot button [PHOTO SHOT]
ª
Connect the free style remote control 
to the camera
1
Plug the free style remote control into the 
[REMOTE] terminal as far as it goes.
ª
About the clip (on the backside)
When you move with the clip fitted to your pocket 
or elsewhere, beware of knocking over the tripod 
and causing the camera to fall off the table.
≥If the pin plug of the control is not inserted 
securely into the [REMOTE] terminal as far as it 
will go, normal operation may not be ensured.
≥Before using, make sure that the plug is 
inserted securely into the terminal as far as it 
will go.
STOP
STILL ADV
VOL
PAUSE STILL ADV
VAR
2
1
(1)
(2)
(3)
GS35_25GN.book  16 ページ  2005年1月31日 月曜日 午後3時25分