Panasonic NV-GS300B User Manual

Record mode

LSQT0974

This reduces the wind noise coming into the 
microphone when recording.
≥Set to Tape Recording Mode.

ª

Set [BASIC] >> [WIND CUT] >> [OFF].

≥The default setting is [ON].
≥Reduces the wind noise depending on the wind 

strength. (If this function is activated in strong 
winds, the stereo effect may be reduced. When 
the wind weakens, the stereo effect will be 
restored.) 

This function prevents unnecessary recording 
when you forget to pause recording and walk with 
the Camcorder tilted upside down while recording 
continues. 
≥If the Camcorder continues to be tilted upside 

down from the normal horizontal position while 
recording on a tape, it is automatically put into 
recording pause.

[AGS]: Auto Ground-Directional Standby
≥Set to Tape Recording Mode.
Set [SETUP] >> [AGS] >> [ON].

ª

Set [SETUP] >> [AGS] >> [OFF].

≥The AGS function may activate and cause the 

Camcorder to pause the recording if you are 
recording a subject right above or right below 
you. In these cases, set [AGS] >> [OFF] then 
continue the recording.

≥Use the recording start/stop button to pause or 

stop the recording. The AGS function is only a 
backup function for when you forget to pause 
the recording. 

≥The time it takes the Camcorder to be put into 

recording pause after being titled upside down 
varies depending on the operating conditions.

Use the built-in flash in order to record still 
pictures in dark places.
≥Set to Tape/Card Recording Mode.

ß] or [ßA].

≥If [

ßA] is selected, then the flash will 

automatically flash as necessary.

≥The flash is activated and the picture will be 

recorded.

≥You cannot use the built-in flash unless the card 

is inserted in the Camcorder.

≥The Camcorder, even when its flash has been 

turned off, automatically determines if the flash 
is necessary by detecting the ambient 
brightness. (If it determines that the flash is 
necessary, the [

] indication lights up in 

yellow.) 

≥When the [

ß] ([ßi]/[ßj]) indication or the [ßA] 

([

ßAi]/[ßAj]) indication is displayed, the flash 

can be lit. If the indication is flashing or not 
displayed, the flash cannot be lit. You can take a 
picture even if the indication is flashing.

≥The available range of the flash is approx. 

1 meter to 2.5 meters  (3 feet to 7.5 feet) in a 
dark place. Pictures will appear dark or reddish 
when they are recorded by using the flash at 
distances greater than 2.5 meters (7.5 feet ). 

≥When set [FLASH] >> [

ßA] and the shutter 

speed, iris or gain is adjusted, the indication 
(either [

ßA], [ßAi], or [ßAj]) may disappear 

and the flash may not be lit.

≥Using the flash fixes the shutter speed of 1/750 

s or faster to 1/500.

≥The picture may become out of focus in a dark 

place. If so, adjust the focus manually.

PHOTO SHOT

LSQT0974_ENG.book  36 ページ  ２００５年１１月７日　月曜日　午前１１時５８分