Panasonic VDR-D300GN User Manual
Se
tup
Inserting/removing an SD card
34
LSQT1025
Inserting/removing an SD card
Before inserting/removing an SD card, be sure to set the OFF/ON switch to OFF.
1 Set the OFF/ON switch to OFF to turn off the power.
≥ Check that the status indicator has gone off.
2 Open the card slot cover.
3 Insert/remove the SD card into/from the card slot.
≥ When inserting an SD card, face the label side A upwards and press
it straight in with one stroke as far as it goes.
≥ When removing the SD card, press the centre of the SD card and
then pull it straight out.
4 Securely close the card slot cover.
∫ Concerning the SD card
≥ Electrical noise, static electricity or failure of this unit or the SD card may damage or erase the
≥ Electrical noise, static electricity or failure of this unit or the SD card may damage or erase the
data stored on the SD card. We recommend saving important data on a computer.
∫ Card access lamp
≥ When this unit accesses the SD card (reading, recording, playback,
≥ When this unit accesses the SD card (reading, recording, playback,
erasing, etc.), the access lamp lights up.
≥ If the following operations are performed when the access lamp is lit,
then the SD card or the recorded data may be damaged or this unit
may malfunction.
– Removing the SD card
– Operating the OFF/ON switch or the mode dial
– Removing the battery or disconnecting the AC adaptor
may malfunction.
– Removing the SD card
– Operating the OFF/ON switch or the mode dial
– Removing the battery or disconnecting the AC adaptor
If the SD card is inserted or removed while the OFF/ON switch is set to ON, this unit may
malfunction or the data recorded on the SD card may be lost.
malfunction or the data recorded on the SD card may be lost.
A
LSQT1025(ENG).book 34 ページ 2006年2月4日 土曜日 午後6時10分