Panasonic NV-GS75EB User Manual

Record mode

VQT0N57

ª

Interlocked with the zooming operation, the 
microphone will collect sounds clearly far away 
with the tele-shot or those in the vicinity with the 
wide-angle shot.
≥Set to Tape Recording Mode.

ª

≥When pushing the [W/T] lever as far as it will go, 

you can zoom from 1

k to 10k in 2.1 second at 

the maximum.

≥The zoom speed varies according to the amount 

of movement of the [W/T] lever.

≥The variable speed zoom function cannot be 

used with the remote control.

You can record yourself while viewing the LCD 
monitor. You can record persons in front of the 
camera while presenting them the image. The 
image is horizontally flipped as if you see a mirror 
image. (The image to be recorded is the same as 
that recording.) 

≥When the LCD monitor is opened, the 

viewfinder will be automatically turned off. If the 
LCD monitor is rotated towards the lens side 
though, then the viewfinder will be activated.

≥When the LCD monitor is rotated towards the 

lens side, the icon will not be displayed even if 
you push the centre of the joystick.

This camera will be put into standby in approx. 
1.7 seconds after the power is turned on.
≥This is only activated in the following cases.

≥A tape or a card is inserted, while the Tape 

Recording Mode is set.

≥A card is inserted, while the Card Recording 

Mode is set.

≥The quick start recording lamp lights up. 

(Press the button again to cancel it.) 

≥The quick start is now ready.

Set the [OFF/ON] switch to [ON].
≥This camera will be put into a recording 

pause in approx. 1.7 seconds after it is turned 
on.

ª

Press and hold the [QUICK START] button for 
approx. 2 seconds. The lamp will go off and the 
camera will be completely turned off. 
≥If the standby continues for approx. 30 minutes, 

then the lamp will go off and the camera will be 
completely turned off.

≥When you rotate the mode dial or remove the 

battery, the quick start recording lamp is turned 
off and the quick start mode is cancelled. If the 
movie camera is turned on and the Tape/Card 
Recording Mode is set though, the lamp turns 
on and the quick start mode is restored.

≥When the camera is quick-started with the white 

balance on automatic, it may take some time 
until the white balance is adjusted if the scene 
being recorded has a light source different from 
the scene last recorded. (When the colour night 
view function is used, however, the white 
balance of the scene last recorded is retained.) 

≥The zoom magnification may differ from when it 

is in the quick start standby mode and when the 
recording starts.

≥Since about half the power of normal recording 

is used in quick start standby, using quick start 
reduces the recordable time.

START

OFF

ON

GS75EB.book  23 ページ  ２００４年１２月２０日　月曜日　午後２時５６分