Panasonic AJ-HDC27A User Manual

52

1/100

1/120

1/250

1/500

1/1000

1/2000

O

No matter in which mode the electronic shutter is
used, the higher the shutter speed, the lower the
camera’s sensitivity.

O

When the aperture is in the automatic mode, it will
increasingly open and the depth of focus will
become shallower as the shutter speed is
increased.

For shooting fast-moving
subjects clearly

Standard

1/100, 1/120, 1/250,
1/500, 1/1000 and
1/2000 (sec.)

For shooting in such a way
that the horizontal striping is
minimized on the monitor
screen

SYNCHRO
SCAN

Between 1/60.0 sec.
and 1/251.3 sec.

Following the steps for “Switching the display
mode” (page 44), set DISP MODE to “2” or “3” on
the CAM VF DISPLAY screen of CAM MENU.

Example: “1/120,” “1/61.2,” etc.

Press the SHUTTER switch from ON to SEL.
The current shutter setting appears on the setting
change message display area of the viewfinder
screen.

Press the SHUTTER switch to the SEL position
again, and repeat this until the desired mode or
speed is displayed.
When all the modes and speeds are displayed, the
display will change in the sequence shown below.
When the required shutter speed and mode have
been assigned beforehand, only the assigned
speed or mode will be displayed.

O

The SHUTTER switch is used to set the shutter
speed and the shutter speed in the standard mode.

O

The shutter speed in the SYNCHRO SCAN mode
can easily be changed using the SYNCHRO (“+”
and “–”) buttons.

O

On the SHUTTER SPEED screen of CAM MENU,
the setting range of the shutter speed can be
restricted to the required range and whether or not
to use the special operation mode (SYNCHRO
SCAN) can be selected.