Panasonic PV-GS65 User Manual
Before using
15
LSQT0860
Charging time and recordable time
The times shown in the table below show the
times at a temperature of 68
times at a temperature of 68
oF (25oC) and a
humidity of 60%. This is just a guide. If the
temperature is higher or lower than the specified
value, the charging time will become longer.
temperature is higher or lower than the specified
value, the charging time will become longer.
A Charging time
B Maximum continuously recordable time
B Maximum continuously recordable time
“1h. 10 min.” indicates 1 hour 10 minutes.
≥The battery CGR-DU06 is supplied.
≥The times shown in the table are rough
≥The battery CGR-DU06 is supplied.
≥The times shown in the table are rough
estimates. The times indicate the recordable
time when the viewfinder is used. The times in
parentheses indicate the recordable time when
the LCD monitor is used.
time when the viewfinder is used. The times in
parentheses indicate the recordable time when
the LCD monitor is used.
≥We recommend the Battery Pack CGA-DU12
and CGA-DU21 for long recording time (2 hour
or more for continuous recording, 1 hour or
more for intermittent recording).
or more for continuous recording, 1 hour or
more for intermittent recording).
≥The recordable time will become shorter in the
following cases:
≥When you use both the viewfinder and the
LCD monitor simultaneously while rotating
the LCD monitor frontward to record yourself,
0 Lux MagicPix function, etc.
the LCD monitor frontward to record yourself,
0 Lux MagicPix function, etc.
≥When you use this Camcorder with the LCD
monitor lit up by pressing the [POWER LCD]
button.
button.
≥The batteries heat up after use or charging. The
Camcorder being used will also heat up. This is
normal.
normal.
≥Along with the reduction of the battery capacity,
the display will change:
r
# s #
t
# u # v. If the battery
discharges, then
u (v) will flash.
Inserting/removing a cassette
1
Slide the [OPEN/EJECT] lever and open the
cassette cover.
cassette cover.
≥When the cover is fully opened, the cassette
holder will come out.
2
After the cassette holder is opened, insert/
remove the cassette.
remove the cassette.
≥When inserting a cassette, orient it as shown
in the figure, and then securely insert it as far
as it goes.
as it goes.
≥When removing, pull it straight out.
3
Push the [PUSH] mark
1 in order to close
the cassette holder.
4
Only after the cassette holder is completely
housed, close the cassette cover.
housed, close the cassette cover.
≥After using, make sure to rewind the cassette
completely, remove it, and put it in a case. Store
the case in an upright position. (
the case in an upright position. (
-62-
)
≥When condensation is formed on the lens or the
main unit of the Camcorder, even if no
condensation alarm is indicated, condensation
may have formed on the heads or the cassette
tape. Do not open the cassette cover. (
condensation alarm is indicated, condensation
may have formed on the heads or the cassette
tape. Do not open the cassette cover. (
-59-
)
ª
When the cassette holder does not
come out
come out
≥Close the cassette cover completely, and then
open it again completely.
≥Check if the battery has run down.
ª
ª
When the cassette holder cannot be
housed
housed
≥Set the [OFF/ON] switch to [OFF], then to [ON]
again.
≥Check if the battery has run down.
Supplied
battery/
CGR-DU06
(7.2 V/
640 mAh)
A
1 h. 40 min.
B
1 h. 25 min.
(1 h. 20 min.)
CGA-DU12
(7.2 V/
1150 mAh)
A
2 h. 25 min.
B
2 h. 40 min.
(2 h. 25 min.)
CGA-DU21
(7.2 V/
2040 mAh)
A
3 h. 55 min.
B
4 h. 30 min.
(4 h. 15 min.)