Panasonic HDC-TM700P/PC User Manual

VQT2M75

∫ Charging the battery

1 Connect the AC cable to the AC adaptor 

and the AC outlet.

2 Insert the battery into the AC adaptor by 

aligning the arrows.

∫ Inserting the battery

Install the battery by inserting it in the 
direction shown in the figure.

A Insert the battery until it clicks and locks.

∫ Inserting/removing an SD card

1)

Open the LCD monitor.

≥ Check that the access lamp has gone off.
2)

Open the SD card/terminal cover and 
insert (remove) the SD card into (from) 
the card slot.

≥ Face the label side B in the direction 

shown in the illustration and press it 
straight in as far as it will go.

≥ Press the center of the SD card and then 

pull it straight out.

3)

Securely close the SD card/terminal 
cover.

≥ Securely close it until it clicks.

∫ Turning the unit on/off

Turning the power on and off with the 
power button
Press the power button to turn on the power.

A The status indicator lights.
≥ To turn off the power, hold down the power 

button until the status indicator goes off.

Turning the power on and off with the 
LCD monitor/viewfinder
Opening the LCD monitor or extending the 
viewfinder turns on the power. Closing the 
LCD monitor/viewfinder turns off the power.
To turn on the power

A The status indicator lights on.

A

≥ When this unit is accessing the SD 

card or built-in memory, the access 
lamp lights up.







A

Lights up:
Charging
Goes off:
Charging completed







HDC-TM700&HS700P&PC-VQT2M75_mst.book  13 ページ  ２０１０年２月２３日　火曜日　午前１０時３４分