Panasonic HDC-TM20P User Guide

VQT1Y00

∫ Charging the battery

1 Connect the AC cable to the AC adaptor and 

the AC outlet.

2 Insert the battery into the AC adaptor by 

aligning the arrows.

∫ Inserting the battery

Install the battery by inserting it in the direction 
shown in the figure.

A Insert the battery until it clicks and locks.

∫ Inserting/removing an SD card

1) Open the LCD monitor.
≥ Check that the access lamp has gone off.
2) Open the SD card cover by sliding the OPEN 

lever 

B.

3) Insert/remove the SD card.
≥ Face the label side C in the direction shown in the 

illustration and press it straight in as far as it will go.

≥ Press the center of the SD card and then pull it 

straight out.

4) Securely close the SD card cover.
≥ Securely close it until it clicks.

∫ How to turn on the power

Turn on the power by changing the mode to 

 

or 

 while pressing the lock release button 

A.

≥ To turn off the power, change the mode to OFF.

A

≥ When this unit is accessing the SD card or 

built-in memory, the access lamp lights up.

A

Lights up:
Charging
Goes off:
Charging 
completed

OPEN

≥ Operate the mode switch while at the same 

time pressing in the lock release button if 
changing from OFF to another mode.

≥ Status indicator B

HDC-SD20

HDC-TM20

≥ Rotate the mode dial while at the same 

time pressing in the lock release button if 
changing from OFF to another mode.

≥ Align with the status indicator B.

OFF

HDC-HS20

HDCSD20&SD25&HS20P-VQT1Y00_eng.book  12 ページ  ２００８年１２月２２日　月曜日　午後８時１６分