Panasonic AG-HSC1UP User Manual
41
VQT1F36
Setup
Setting date and time
When the unit is turned on for the first time, a
message asking you to set the date and time will
appear.
≥Move the cursor button up or down to select
message asking you to set the date and time will
appear.
≥Move the cursor button up or down to select
[YES], press the center of the cursor button and
then perform steps 2 and 3 below to set the
date and time.
then perform steps 2 and 3 below to set the
date and time.
If the screen shows the incorrect date and time,
then adjust it.
then adjust it.
¬
Rotate the mode dial to select
.
1
Press the MENU button, then
select [BASIC]
select [BASIC]
#
[CLOCK SET]
#
[YES]
and press the cursor
button.
2
Move the cursor button left or
right to select the item to be set.
Then, move the cursor button up
or down to set the desired value.
right to select the item to be set.
Then, move the cursor button up
or down to set the desired value.
≥The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥The 12-hour system is used to display the
time.
3
Press the cursor button to enter
the selection.
the selection.
≥The clock function starts at [00] seconds
when the cursor button is pressed.
≥After pressing the MENU button to finish
the setting, check the date and time
display.
display.
Changing the date and time display style
Press the MENU button, then select [SETUP]
#
[DATE/TIME]
# desired display style and press
the cursor button.
≥You can also show or change the date and time
≥You can also show or change the date and time
display by repeatedly pressing the DATE/TIME
button on the remote control.
button on the remote control.
Changing the display style
Press the MENU button, then select [SETUP]
#
[DATE FORMAT]
# desired display style and
press the cursor button.
≥The date and time function are driven by a
built-in lithium battery.
≥Make sure to check the time before recording.
≥If the time display becomes [- -], the built-in
≥If the time display becomes [- -], the built-in
lithium battery has run down. Use the following
steps to charge the battery. When you turn on
the power for the first time after charging, a
message asking you to set the date and time
will appear. Select [YES] and set the date and
time.
steps to charge the battery. When you turn on
the power for the first time after charging, a
message asking you to set the date and time
will appear. Select [YES] and set the date and
time.
To recharge the built-in lithium battery:
If you connect the AC adaptor or insert the
battery in this unit, the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (The battery is still
being recharged even if the mode dial is set to
OFF.)
battery in this unit, the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (The battery is still
being recharged even if the mode dial is set to
OFF.)
[DATE]
[D/T]
[OFF]
Display style
Screen display
[Y/M/D]
2007.12.15
[M/D/Y]
DEC 15 2007
[D/M/Y]
15.12.2007
DEC 15 2007 3:30PM
DEC 15 2007
VQT1F36_ENG_PP.book 41 ページ ２００７年２月２６日 月曜日 午前１１時２９分