Panasonic AG-HPX600EJ User Manual

– 25 –

Display the [CAMERA] screen on SmartUI.

Display the [AUDIO] screen on SmartUI.

Display the [SETUP] screen on SmartUI.

Display the [HOME] screen on SmartUI.

Disable button operations related to SmartUI and thumbnail 
operations. However, <LIGHT> button operation is available.

22 <USB2.0> terminal (device) (page 146)
23 <USB2.0> terminal (host) (page 146)

Connect the USB 2.0 cable.
When the [PC MODE] item on the setting menu [PC/USB/LAN] 
screen is set to [ON], data transfer using USB 2.0 is enabled.
In this state, recording/playback and clip operations on the camera 
are limited.

Indicate the access status of recording and playback of each card.

This is the insertion slot for the SD memory card (optional). Use the 
SD memory card for recording/opening the setting menu and lens 
files for the camera, or uploading metadata or proxy recording (extra-
cost option), etc.

@

@

 tCautions in using SD memory cards

- On the camera, use SD memory cards that are compliant with 

the SD standard or the SDHC standard.

- MMC (Multi Media Card) cannot be used. (Bear in mind that 

taking pictures may no longer be possible if you do use them.) 

- When using miniSD/microSD cards with the camera, always 

install the adaptor specially designed for miniSD/microSD 

cards. (The camera will not work properly if only the miniSD/

microSD adaptor is installed. Make sure that the card has 

been inserted into the adaptor before use.)

- Use of Panasonic SD memory cards and miniSD/microSD 

cards is recommended. Be sure to format cards on the 

camera before use.

- Any SD memory card with a capacity of 8 MB to 2 GB and any 

SDHC memory card up to 32 GB can be used on the camera. 

Also, when performing proxy recording (extra-cost option), use 

SDHC memory cards or SD memory cards with a capacity of 

256 MB to 2 GB marked “High Speed”, etc.

- For the latest information not available in the Operating 

Instructions, visit the support desk at the following website:

http://pro-av.panasonic.net/

Indicate the active status of the SD memory card, and is illuminated 
when the card is active.

@

@

 tDo not insert or remove the card while the lamp is lit. This might 

damage the SD memory card.

Output the SDI signal.

 

f

By installing the HD/SD SDI input board (optional), SDI signals can 
be input. (page 167)

This is the video output terminal for the monitor. Video independent 
from the <SDI OUT/IN (OP)> terminal can be output. Also, HD SDI 
signal or down-converted SD SDI signal, or VBS signal can be 
selected on the [SET02:MON/HDMI FORMAT] screen of SmartUI. 
Cross-conversion and up-conversion are not supported.

Enabled when the network function (extra-cost option) is installed.
For the cable to be connected to the <LAN> terminal, use the 
shielded cable.

31 <HDMI> terminal (page 49)
32 <USB2.0> terminal (sub-host)

Attach the wireless module AJ-WM30 (optional).

Turn on/off the function for enlarging the video at the center of the 
screen.