Panasonic HDC-DX1PC User Manual

LSQT1093

ª Screen indications in the disc 

A Recording mode
B Remaining time left for recording

(When the remaining time is less than 
1 minute, [R0min] flashes red.)

C Recording time elapsed

≥The maximum number of scenes on a disc (per 

side): 999 (Even if there is remaining capacity 
for recording on a disc, you may not be able to 
record 999 scenes.)

≥The maximum number of recordable scenes 

with different dates (on one side of the disc): 99
(In some cases, scenes recorded on the same 
day will be recorded with different dates 
(l 77))

≥Discs with more than the maximum scenes or 

dates cannot be used with this unit.

≥Sound is recorded from the internal 

microphones on the top of this unit. Take care 
not to block this microphone.

≥Put the unit in pause mode when connecting or 

disconnecting an external microphone with the 
MIC terminal. If an external microphone is 
connected or disconnected while recording, the 
audio will not be recorded properly.

≥Each time the unit is put into recording pause, 

the counter display will be reset to “0h00m00s”.

≥While motion picture recording is in progress, 

the recording will not stop even if the LCD 
monitor is closed and the viewfinder is 
retracted.

≥While “WRITING CONTROL DATA TO THE 

DISC. DO NOT SHAKE THE UNIT.” is 
displayed, do not disconnect the AC adaptor or 
remove the battery as doing so may make the 
disc unusable.

≥While motion picture recording is in progress, 

do not disconnect the AC adaptor or remove 
the battery. If you do, a repair disc message 
may be displayed when the power is turned 
back on. (l 115)

B
C

A

The ACCESS/PC lamp lights immediately 
after recording finishes. While it lights, the disc 
is rotating and disc information is being 
recorded. If you run while holding the unit or 
swing it, the recorded images may be 
distorted so do not strongly shake or cause 
impact to it.

LSQT1093ENG.book  51 ページ  ２００７年１月１５日　月曜日　午前９時２３分